EasyManua.ls Logo

Rohde & Schwarz SMB100A - Replacing the Battery (G1)

Rohde & Schwarz SMB100A
223 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R&S SMB Module Replacement
1407.0806.82 3.49 E-6
Replacing the Battery (G1)
The lithium battery is accommodated on the basis board.
CAUTION Danger of injury
Lithium batteries must not be exposed to high temperatures or fire.
Keep away from children.
If the battery is replaced improperly, there is danger of explosion. Only replace
the battery by R&S type (see also
“Overview of the Modules”
, page 3.38).
Lithium batteries are hazardous waste and must be disposed of in dedicated
containers.
Do not short-circuit the battery!
Carefully lift and pull out the battery.
Note: 3.0 V lithium battery (
24,5 mm * 7,7 mm , type CR2477N),
see also
“Overview of the Modules”
, page 3.38.
Insert new battery into holder below the spring.
Note: The positive pole (+) of the battery should point up.

Table of Contents

Other manuals for Rohde & Schwarz SMB100A

Related product manuals