Rohde & Schwarz SMB100A - Installing the Options; Hardware Options

Installing the Options R&S SMB
1407.0806.82 4.2 E-5
1. Switch on the instrument and wait until it is operational.
2. Plug in the memory stick which contains the update file (previously downloaded from the Internet) to
t
he USB interface of the instrument.
3. Wait until the software update dialog appears and confirm the update.
4. Select the firmware version to be installed with the cursor up/down keys and press the rotary knob to
activate your selection. The selected version will be installed.
5. Wait until the software update completed message appears.
6. Remove USB stick and press the rotary knob to reboot.
7. When the new/updated firmware is up and running, execute internal adjustments after a warmup
time of approx. 10 minutes.
 Press the
SETUP key on the instrument front panel, select Internal Adjustments and execute
Adjust All.
This process updates internal instrument adjustments and can take several minutes.
Adjustments requiring external measurement equipment are not affected by the firmware update
and need not to be performed.
Installing the Options
A list of all available R&S SMB options is provided in the data sheet and on the internet
http://www.rohde-schwarz.com/product/smb100a
.
Hardware Options
Installation and replacement of hardware options is described in chapter 3 of this service manual.
Please also note the mounting instructions enclosed with the options. These mounting instructions can
be filed at this place in the service manual and are thus easily available whenever they are required.
DANGER Danger of shock hazard
For module replacement, ensure that the instrument is switched off and disconnected
from the power supply by removing the plug from the AC and DC power connector.
Read all safety instructions at the beginning of this manual carefully before module
replacement!
NOTICE Danger of damage to components of the module
Protect the operational site against electrostatic discharge to avoid damage to
electronic components of the modules. For details refer to the safety instructions at
the beginning of this manual.
The SETUP Installed Options menu provides information on the already installed options.