Troubleshooting R&S SMB
1407.0806.82 3.34 E-6
Error Messages concerning the Stereo/RDS Coder module
Error message Error correction
"Stereo Coder not ready. Please reboot
R&S SMB.”
Restart R&S SMB. If error persists, most probably the
Stereo Coder module or the ribbon cable W108 is
defective.
"General stereocoder hardware error"
"General stereocoder DSP error"
Restart R&S SMB. If error persists, most probably the
Stereo Coder module is defective.
"Stereocoder I2C Bus error"
Retry Stereo Coder access. If access fails, restart
R&S SMB. If error persists, most probably the Stereo
Coder module or the ribbon cable W108 is defective.
"Stereocoder realtime clock error"
"General stereocoder software error"
“Stereocoder RDS mailbox not ready”
Restart R&S SMB. If error persists, most probably the
Stereo Coder module is defective.
“Stereocoder DSP overflow” Reconfigure Stereo Coder commands. If error
persists, restart R&S SMB.
“Stereocoder RDS configuration error” Reconfigure RDS consistently.
“Stereocoder command syntax error” Repeat command using correct syntax
“Invalid stereocoder command parameter” Repeat command with correct parameters.
“Stereocoder receiver overflow” Restart R&S SMB.
“Stereocoder offset adjustment failed“ Reboot and repeat internal Stereo Coder adjustment.
If adjustment still fails, check the Stereo coder signal
path (see page 3.36).
“Stereocoder gain adjustment failed” Reboot and repeat internal Stereo Coder adjustment.
If adjustment still fails, check the Stereo coder signal
path (see page 3.36).
“Stereocoder S/P DIF adjustment failed” Make sure correct setting and connection of external
S/P DIF source. Reboot and repeat internal Stereo
Coder adjustment. If adjustment still fails, check the
Stereo coder signal path (see page 3.36).
To Next Page
Loading...
