Module Replacement R&S SMB
1407.0806.82 3.46 E-6
NOTICE Risk of damage to the board
The ribbon cable connector must be carefully folded up.
Open the clips from the display frame (1406.7594.00) and remove the display (1407.3586.00).
Replace the powder seal (1406.7588.00) for a new one and clip the new display into the display
frame.
NOTICE Risk of damage to the board
When installing the items, make sure they are free of dust.
Connect the flex-strip (W 330) in the correct position.
Fit the holding plate and fix it with eight combination screws (1148.3059.00).
Fit the encoder board (W310) with two combination screws (1148.3059.00).
To Next Page
Loading...
