101
Recording
3.
Press the button of the track you want to record, so the button is blinking.
This setting lets you record while listening to the selected song.
The [Rec] button will light, the [Play] button will blink, and the instrument will enter recording
standby mode.
If you decide not to record, press the [Rec] button once again.
Starting Recording
4.
Press the [Play] button.
After two measures of count sound, recording begins.
Recording starts when you start playing the keyboard (without pressing the [Play] button). In this
case, a count is not sounded.
When recording begins, the [Rec] button and [Play] button will light.
During the count-in, the count measure is indicated in the display as “-2” then “-1.”
Stopping Recording
5.
Press the [Play] button.
Recording will stop.
If you record without erasing the existing song, the song tempo, time signature, and
metronome settings will remain as they were for the first recording.
Listening to the Recorded Performance
6.
Press the [-] button to return to the beginning of the song you recorded.
7.
Press the [Play] button.
The recorded performance will play back.
8.
Press the [Play] button once again to stop playback.
The recorded performance will disappear when you turn off the power. If you want to
keep the performance you recorded, you must save it in internal memory or on USB
memory. Refer to “Saving the Songs You Record” (p. 105).
Track buttons
Description
Blinking
The performance will be recorded.
If performance data already exists, the existing performance will be erased
and replaced as the new recording proceeds.
Lit
The performance will not be recorded.
During recording, the performance located at this track button will play back.
Unlit
The performance will not be recorded.
This track does not contain performance data.
NOTE
NOTE
FP-7-e.book 101 ページ ２００６年１２月１４日 木曜日 午前１０時５７分
To Next Page
Loading...
Need help?
General
