96
Recording
3.
Press the [Rec] button once again.
The following screen appears.
4.
Press the button of the track you want to record, so the button is blinking.
This setting lets you record while listening to the selected song.
The [Rec] button will light, the [Play] button will blink, and the instrument will enter recording
standby mode.
If you decide not to record, press the [Rec] button once again.
How the track buttons correspond to an internal song’s performance parts
Starting Recording
5.
Press the [Play] button.
After two measures of count sound, recording begins.
Recording starts when you start playing the keyboard (without pressing the [Play] button). In this
case, a count is not sounded.
When recording begins, the [Rec] button and [Play] button will light.
During the count-in, the count measure is indicated in the display as “-2” then “-1.”
Track button Description
Blinking
The performance will be recorded.
If performance data already exists, the existing performance will be erased and
replaced as the new recording proceeds.
Lit
The performance will not be recorded.
During recording, the performance located at this track button will play back.
Unlit
The performance will not be recorded.
This track does not contain performance data.
Track button Performance part
Track [1] button
Left-hand part
Track [2] button
Right-hand part
Track [R] button
For internal song numbers 1–5, this track contains performance data other than
the right-hand part and left-hand part.
For internal song numbers 6–65, this track does not contain performance data.
FP-7-e.book 96 ページ ２００６年１２月１４日 木曜日 午前１０時５７分
To Next Page
Loading...
Need help?
General
