133
Various Settings
6.
Press the [Rec] button.
Initialization will begin.
The entire contents of internal memory will be erased.
* Never turn off the power while the screen indicates
“Executing.” Doing so may destroy the FP-7’s
memory, rendering it unusable.
This operation will not initialize any settings other
than the contents of internal memory. If you want to
return settings other than internal memory to the
factory-set state, please execute Factory Reset (p.
135) or Initializing USB memory (p. 133).
You can initialize (format) USB memory that’s connected to the
FP-7. If you want to erase the entire contents of USB memory
and return it to the condition in which you purchased it,
execute the following procedure.
1.
Press the [Function] button.
2.
Press the Track [2] button.
The Format screen appears.
3.
While holding down the [Display] button, use
the [-] [+] buttons to select “External Memory.”
4.
Press the [Display] button.
A confirmation message will appear.
If you want to return to the previous screen without
formatting, hold down the [Display] button, use the [-] [+]
buttons to select “Cancel,” then press the [Rec] button.
5.
While holding down the [Display] button, use
the [-] [+] buttons to select “OK.”
6.
Press the [Rec] button.
Initialization will begin.
The entire contents of USB memory will be erased.
* Never turn off the power while the screen indicates
“Executing.” Doing so may destroy the USB memory,
rendering it unusable.
Don’t remove the USB memory until formatting is
completed.
This operation will not initialize any settings other
than the contents of USB memory. If you want to
return settings other than USB memory to the factory-
set state, please execute Factory Reset (p. 135) or
Initializing internal memory (p. 132).
Initializing USB Memory
NOTE
NOTE
NOTE
FP-7-e.book 133 ページ ２００６年１２月１４日 木曜日 午前１０時５７分
To Next Page
Loading...
Need help?
General
