56
Performing
You can add liveliness to the sound to give it superb clarity and distinctness.
fig.Panel-SoundControl.eps
1.
Press the [Sound Control] button so it’s lit.
The Sound Control function is switched on, enlivening the sound.
2.
While holding down the [Sound Control] button, press the [-] or [+] button
to change the type.
fig.d-1.eps
Turning Off Sound Control
1.
Press the [Sound Control] button so its light is turned off.
You can specify the Sound Control setting that will be selected when the power is
turned on. Please refer to “Specifying the Sound Control Setting at Power-on” (p. 122).
For some sounds, this may cause distortion. If the sound distorts, refer to “Adjusting the
Volume (Master Gain)” (p. 123).
The Sound Control function is not applied to the sounds of external devices connected
to the Input jacks.
Adding Liveliness to the Sound (Sound Control)
Setting
Description
Sharp
Creates a sound with boosted bass and treble.
Clear
Produces a sound with chords in the low registers that are clear and distinct.
Power
Creates a sound with boosted bass.
NOTE
NOTE
FP-7-e.book 56 ページ ２００６年１２月１４日 木曜日 午前１０時５７分
To Next Page
Loading...
Need help?
General
