44
Performing
When the [Registration] button is lit, Tone buttons ([1]–[7]) can be pressed to select registrations.
If you want to select a tone, press the [Registration] button to turn off its light.
1.
Press the [Piano] button.
Now, the piano tone is selected.
fig.d-1.eps
2.
Press the [Split] button, getting its indicator to light.
The keyboard will be divided into left and right sides.
The F 3 key forms the division between the left and right sides of the keyboard.
The right-hand section of the keyboard plays piano tone, and the left-hand section plays
“A. Bass+Cymbl” (Acoustic Bass + Cymbal) tone.
You can play a tone for the right side (the Upper Tone) before splitting the keyboard.
Turning Off Split Play
1.
Press the [Split] button so its illumination is turned off.
The [Split] button’s indicator light goes out and the upper tone becomes the tone for the entire
keyboard.
You can vary the volume-level balance of the two tones. Take a look at “Changing the
Volume Balance for Dual Play and Split Play” (p. 47).
When you switch from Dual Play (p. 41) to Split Play, the Upper Tone used in Dual
Play is selected as the Upper Tone for Split Play.
You can specify which part is to have priority when the effects assigned to the Upper
Tone and Lower Tone differ. Refer to “Setting the Part to Which Effects Are Added” (p.
120).
FP-7-e.book 44 ページ ２００６年１２月１４日 木曜日 午前１０時５７分
To Next Page
Loading...
Need help?
General
