EasyManuals Logo

Roland GO:KEYS 5 Reference Manual

Roland GO:KEYS 5
75 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
62
Editing the system settings
29 29 JUNO Chorus JUNO Chorus (JUNO-106Chorus)(JUNO-106Chorus)
This models the chorus eects of the Roland JUNO-106.
L out
R out
L in
R in
Balance D
Balance D
Balance W
Balance W
Chorus
Noise
Generator
Noise
Generator
Parameter Value Explanation
Mode I, II, I+II, JX I, JX II
Type of Chorus
I+II: The state in which two buttons are
pressed simultaneously.
Noise Level 0–127 Volume of the noise produced by chorus
30 30 Ring ModRing Mod
This is an eect that applies amplitude modulation (AM) to the input
signal, producing bell-like sounds. You can also change the modulation
frequency in response to changes in the volume of the sound sent into
the eect.
L in L out
R outR in
Ring Mod 2-Band EQ
Ring Mod 2-Band EQ
MEMO
This eect can be used for both TOTAL FX and MFX. The parameters
than you can set when using the eect with the MFX are limited to
those marked with a (*1).
Parameter Value Explanation
Sens
(*1)
0–127
Adjusts the amount of frequency
modulation applied.
Frequency
(*1)
0–127
Adjusts the frequency at which
modulation is applied.
Polarity UP, DOWN
Determines whether the frequency
modulation moves towards higher
frequencies or lower frequencies.
UP: The filter will change toward a
higher frequency.
DOWN: The filter will change toward a
lower frequency.
Low Gain -15–+15 [dB]
Amount of boost/cut for the low-
frequency range
High Gain -15–+15 [dB]
Amount of boost/cut for the high-
frequency range
Balance
D100: 0W–D0:
100W
Volume balance between the direct
sound
(D) and the effect sound (W)
Level 0–127 Output Level
31 31 TremoloTremolo
Cyclically changes the volume.
L in L out
R outR in
Tremolo 2-Band EQ
Tremolo 2-Band EQ
Parameter Value Explanation
Rate
(Hz)
0.05–10.00 [Hz] Frequency of the change
Depth 0–127 Depth to which the effect is applied
32 32 Auto PanAuto Pan
Cyclically modulates the stereo location of the sound.
L in L out
R outR in
Auto Pan 2-Band EQ
Auto Pan 2-Band EQ
MEMO
This eect can be used for both TOTAL FX and MFX. The parameters
than you can set when using the eect with the MFX are limited to
those marked with a (*1).
Parameter Value Explanation
Depth
(*1)
0–127 Depth to which the effect is applied
Rate
(Hz)
0.05–10.00 [Hz]
Frequency of the change
Rate
(note) (*1)
Note
Ø “Note” (p. 75)
Mod Wave
TRI, SQR, SIN,
SAW1, SAW2, TRP
Modulation Wave
TRI: Triangle wave
SQR: Square wave
SIN: Sine wave
SAW1/2: Sawtooth wave
TRP: Trapezoidal wave
SAW1 SAW2
R R
L L
Sync OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
Ø “Changing the tempo (TEMPO)” (p. 36)
Low Gain -15–+15 [dB]
Amount of boost/cut for the low-
frequency range
High Gain -15–+15 [dB]
Amount of boost/cut for the high-
frequency range
Level 0–127 Output Level

Table of Contents

Other manuals for Roland GO:KEYS 5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roland GO:KEYS 5 and is the answer not in the manual?

Roland GO:KEYS 5 Specifications

General IconGeneral
BrandRoland
ModelGO:KEYS 5
CategoryElectronic Keyboard
LanguageEnglish

Related product manuals