Roland Jupiter-80 - Phones Jack

Panel Descriptions
21
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
SUB OUT jacks
You can connect speakers here for use as monitors,
or for outputting only the reverb sound. The system
setting “Output Assign” (p. 86) species which sounds
will be output from the SUB OUT jacks.
MAIN OUT (TRS) jacks
Connect your speakers here. To employ monaural
output, connect to the L/MONO jack.
MAIN OUT (XLR) jacks
These are balanced output jacks for audio signals.
Connect them to your mixer.
PHONES jack
You can connect a set of headphones
(sold separately) here.
1: GND2: HOT
3: COLD
1: GND 2: HOT
3: COLD
TIP: HOT
RING: COLD
SLEEVE: GND
1: GND2: HOT
3: COLD
1: GND
2: HOT
3: COLD
TIP: HOT
RING: COLD
SLEEVE: GND
This instrument is equipped with balanced (XLR/TRS) type jacks. Wiring diagrams for these jacks are
shown below. Make connections after rst checking the wiring diagrams of other equipment you
intend to connect.
AUDIO IN (STEREO) jack
Connect your digital audio player or audio playback device here.
Use a stereo mini-plug cable (commercially available) to make the
connection.
The input level is adjusted by the [LEVEL] knob located at the left of the jack.