Roland Jupiter-80 - Playing the JUPITER-80 from an External MIDI Device; Setting the Receive Channel; Setting the Program Change Receive Switch

Connecting an External MIDI Device
93
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Playing the JUPITER-80 from an
External MIDI Device
Connection example
MIDI OUT connector
MIDI IN connector
MIDI keyboard
JUPITER-80
Setting the Receive Channel
You’ll need to match your external MIDI device’s transmit channel
with the JUPITER-80’s receive channel.
1. In the System Setup screen, touch <MIDI> (p. 85).
2. In Part Channel, specify the MIDI channel of each Part.
3. To save the settings, touch <SYSTEM WRITE>.
Setting the Program Change Receive
Switch
Here’s how to turn on the receive switch for program change and
bank select messages. With the factory settings, both are turned
“ON.”
1. In the System Setup screen, touch <MIDI Tx/Rx> (p. 85).
2. Turn on Receive Program Change and Receive Bank
Select.
3. To save the settings, touch <SYSTEM WRITE>.
MEMO
• For details on these settings, refer to “MIDI Tx/Rx” (p. 85).
• For details on how to set the transmit channel of your external
MIDI device, refer to its owner’s manual.