Roland Jupiter-80 - Layer On;Off and Volume Adjustment; Switching the MFX (Multi-Effects)

Editing a Live Set
58
Layer On/O and Volume Adjustment
To turn a layer on/o, touch its layer number in the Live Set screen
(p. 32).
Layer button Status
O
On
MEMO
In the panel’s PART BALANCE area you can turn the four layers
on/o and adjust their volume.
Use the sliders to adjust
the volume of each
layer.
The level meters show
the volume setting of
each layer.
Turn each layer on/o.
MEMO
By holding down the [SHIFT] button and operating the panel’s
PART BALANCE area, you can turn the Parts (Solo, Upper, Lower,
Percussion) on/o and adjust their volume.
Switching the MFX (Multi-eects)
Each Live Set contains four MFX (multi-eects) processors.
To switch the MFX, access the “Live Set Eects Routing” screen.
1. In the Live Set Eects Routing screen (p. 33), touch the MFX
eect type to access a list.
Touch an eect type.
The MFX Type screen will appear. In this example, the eect type for
MFX1 of the Live Set selected for the Upper Part is changed.
MEMO
If you move the cursor to the eect type, you’ll also be able to
use the value dial or the [DEC] [INC] buttons to switch the eect
type.
2. Touch the new eect type, and then touch <Select>.
Select a category.
Select an eect type.
Conrm your selection.
1
2
3
The left column lists the eect type categories, and the right
column lists the eect types in the selected category.
The eect type will change.