Roland Jupiter-80 - Placing the JUPITER-80 on a Stand

22
Be careful not to pinch your ngers when setting up the stand.
If you want to place the JUPITER-80 on a stand, use the Roland KS-18Z or KS-G8.
Place the instrument on the stand as follows.
KS-18Z
Align the front of the
JUPITER-80 with the
front of the stand
Adjust so that
the height does
not exceed 1
meter (Adjust
the stand to a
level no higher
than the fourth
level from the
bottom)
Adjust the width of the stand
so that the rubber feet of the
JUPITER-80 straddle the stand
Top view
KS-G8
Align the front of
the JUPITER-80
with the front of
the stand
Top view
Place the JUPITER-80 so
that it’s rubber feet are in
the inner side of the stand
Placing the JUPITER-80 on a Stand