Roland Jupiter-80 - Turning MFX On;Off; Adjusting the Effect Send Levels and Effect Output Levels; Editing the MFX

Editing a Live Set
59
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Turning MFX On/O
To switch an MFX on/o, touch its MFX button.
MFX button Status
O
On
Adjusting the Eect Send Levels and
Eect Output Levels
You can adjust the level at which the sound of each layer is sent to
MFX, and the output level of the sound that has passed through the
eect.
Set the level of sound sent to
MFX or reverb.
Set the level of sound sent from
MFX to reverb.
Set the output destination
and output level of the
selected layer.
Set the output level
of MFX or reverb.
Editing the MFX
To edit MFX settings, access the “Live Set Eects Routing” screen (p.
33).
1. In the Live Set Eects Routing screen (p. 33), touch MFX’s
<EDIT>.
In this example, we’ll edit the Multi Tap Delay eect for MFX1 of the
Live Set selected for the Upper Part.
The Live Set MFX screen will appear.
2. Edit the MFX settings.
The parameters that can be edited will depend on the eect
type you’ve selected. For details on MFX parameters, refer to the
parameter list in the PDF manual.