Roland Jupiter-80 - Initializing a USB Flash Drive (Format); Disabling the Registration Buttons

Settings and Convenient Functions
81
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Initializing a USB Flash Drive
(Format)
This operation will initialize (format) a USB ash drive.
NOTE
When you execute this operation, all data saved on the USB
ash drive will be lost. If the USB ash drive contains important
data, back it up to your computer before initializing the USB
ash drive.
1. In the MENU screen (p. 34), touch <Format USB Memory>.
The Format USB Memory screen will appear.
2. Touch <EXEC>.
A message will ask “Are you sure?”
3. To initialize, touch <OK>.
NOTE
Never turn o the power while an USB ash drive is being
formatted.
Disabling the Registration Buttons
The JUPITER-80’s settings will change if you press a Registration
button unintentionally or switch Registration Sets.
Use the “Registration Button Lock” function if you don’t want the
Registration buttons to switch Registrations while you perform.
1. In the MENU screen (p. 34), touch <Regist Button Lock>.
The Registration Button Lock screen will appear.
2. Touch <LOCK>.
The Registration buttons will be disabled.
3. Press [EXIT] button.
MEMO
• To enable the Registration buttons, release Registration Button
Lock (touch <UNLOCK>).
• Even when Registration Button Lock is on, you can still switch
Registrations by operating the touch panel or the top panel.
• The state of Registration Button Lock is not saved. It will
automatically be UNLOCK when you turn on the power.
• When Registration Button Lock is on, a “Lock” symbol is shown
by the Registration name.