Set “Margin” to “1 mm.”
Click [OK].
For printing on a at plate, make the
margin at least one millimeter. Other-
wise the marking pin may strike and
damage the edge of the material.
Step2 : Import the Image
Here you import an image (such as photograph or drawing) for printing.
Data formats supported by METAZAStudio
Files in JPEG format
Files in BMP (bitmap) format
Files in AI or EPS format created by Illustrator version 7 or 8
Files in AI or EPS format exported by CorelDRAW version 7 or 8
Note : Illustrator and CorelDRAW les are subject to a number of limitations. For details, see the online help
for METAZAStudio.
METAZAStudio online help ("Hints and Tips" > "Reusing Existing Data")
Procedure
Click .
The [Import] dialog box appears.
To Next Page
Loading...
Need help?
General