53
Chapter 3 Making Prints
3-4 Starting and Stopping Print
Click the [Image Correction]
tab.
Select [Material].
Select either the composition or the
product code of the material.
You can adjust and register the striking
force.
P. 92, "Registering a Composition and
Adjusting the Striking Force"
Select Print mode.
P. 92, "Registering a Composition and
Adjusting the Striking Force," METAZA Driver
online help ([Correction] tab)
Click [OK].
Click [OK].
The printing data is sent to the machine
and printing starts.
After printing has nished, open the cover and detach the material.
Do not open the cover until the operation is completely stopped.
If the material is dicult to detach when using the adhesive sheet, inserting a thin, at object (such as
a piece of sti paper or cardboard) between the adhesive sheet and the material may make it easier to
dislodge.
To Next Page
Loading...
