Roland Metaza MPX-90 - Page 98

96
5-4 Adjustment of the Origin-point Location
Chapter 5 Maintenance and Adjustment
2. Measure the displacement of Origin-point Location and type in the correction values.

Measure and note down the offset
between the centerline on the
table scale and the crossed lines
on the material.
In the example shown in the gure, the
[Width] value is displaced by 0.5 mm in
the positive direction and the [Length]
value is oset by 0.5 mm in the negative
direction.

Windows 7
From [Start] menu, click [Control Panel] → [Hardware and Sound] → [Devices and
Printers].
Windows Vista
From [Start] menu, click [Control Panel] → [Hardware and Sound] → [Printers].
Windows XP
From [Start] menu, click [Control Panel] → [Printers and Other Hardware] → [Printers
and Faxes].
The [Printers] folder opens.

Right-click [Roland MPX-90].
Click [Printing Preferences].
The setting window of METAZA Driver
appears.
Center line
Center
Positive direction
for [Length]
Positive direction
for [Width]
Material