150
Sound Keeps Playing
When Key is Pressed
Is the pedal polarity reversed?
• Check the System Pedal Polarity settings in Edit mode.
p. 111
Exclusive Messages
Cannot Be Received
Is the Device ID number of the transmitting device matched to the RD-700GX’s Device ID
number?
• Check the System Device ID settings in Edit mode.
p. 110
Song Data Not Played
Back Correctly
Is the Receive GM/GM2 System On Switch set to ON?
• Set the System Rx GM System On or System Rx GM2 System On to ON in Edit mode.
p. 112
Are you playing back GS Format song data?
• Once the RD-700GX receives a GS Reset message, it then is enabled for GS Format. This permits
playback of music files bearing the GS logo (GS music files). However, data created exclusively
for the Sound Canvas Series may not play back properly on the RD-700GX.
—
Is the audio data playable?
Make sure that the audio data can be played by the RD-700GX.
p. 153
Pedal function is not
affected
Is the System Pedal Mode setting in Edit mode set to “SYSTEM”?
• Set this to “SETUP”.
p. 108
[S1] [S2] buttons’ function
is not affected
Is the System S1/S2 Mode setting in Edit mode set to “SYSTEM”?
• Set this to “SETUP”.
p. 108
Nothing appears in the
screen
Since the RD-700GX uses a liquid crystal screen, it may happen that no text or graphics
appear in the screen if the temperature is below zero degrees Celsius (32 degrees
Fahrenheit).
—
Vertical lines appear in
the screen/Color is
“washed out” at the
edges of the screen
These occur due to the nature of a liquid crystal display, and do not indicate a malfunction.
They can be minimized by adjusting the contrast of the screen.
—
Pedal does not work, or is
“stuck”/
Pedal does not operate
correctly
Is the pedal connected correctly?
Plug the cord firmly into the pedal jack.
p. 23
Are you using a pedal made by another manufacturer?
Use the pedal included with the RD-700GX or an optional DP Series or similar pedal.
p. 23
Can’t read or write USB
memory successfully
Are you using (optional) Roland USB memory?
Reliable performance cannot be guaranteed if you use non-Roland USB memory products.
—
If you are unable to read or write USB memory successfully, change the USB Memory Mode
setting.
p. 142
Reverberation remains
even if you defeat the
Reverb effect
The RD-700GX’s piano sound faithfully simulates the depth and resonance of an acoustic
piano, and this may give the impression of reverberation even if you’ve defeated the Reverb
effect.
—
The sound of the higher
notes suddenly changes
from a certain key
On an acoustic piano, the approximately one and a half octaves of notes at the top of the
keyboard will continue sounding regardless of the damper pedal. These notes also have a
somewhat different tonal character. RD-700GX faithfully simulate this characteristic of
acoustic pianos. On the RD-700GX, the range that is unaffected by the damper pedal will
change according to the key control setting.
—
High-pitched ringing is
heard
Piano sounds that have a brilliant and crisp character contain substantial high-frequency
components that may sound as though a metallic ringing has been added. This is because
the character of an actual piano is being faithfully reproduced, and is not a malfunction. This
ringing is more obtrusive if the reverb effect is applied heavily, so you may be able to
minimize it by decreasing the reverb.
—
Low notes sound wrong,
or are buzzy
With certain tones, the sounds may seem to be distorted.
Turn down the volume. Alternatively, lower the master gain setting.
—
Problem
Check/Solution Page
RD-700GX_e.book 150 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
