Roland RD-700GX User Manual

161
Effect/Parameter List
30: 3D FLANGER
This applies a 3D effect to the flanger sound. The flanger
sound will be positioned 90 degrees left and 90 degrees right
.
31: 3D S.FLANGR (3D STEP FLANGER)
This applies a 3D effect to the step flanger sound. The flanger
sound will be positioned 90 degrees left and 90 degrees
right.
32: 2BND CHORUS (2BAND CHORUS)
A chorus effect that lets you apply an effect independently to
the low-frequency and high-frequency ranges.
Parameter
Value Description
Filter Type
OFF,
LPF,
HPF
Type of filter
OFF : No filter is used
LPF : Cuts the frequency range above
the Cutoff Freq
HPF : Cuts the frequency range below
the Cutoff Freq
Cutoff Freq 200–8000 Hz Basic frequency of the filter
Pre Delay 0.0–100.0 ms
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Mode Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00 Hz Frequency of modulation (Hz)
Rate ( ) note (*1) Frequency of modulation (note)
Depth 0–127 Modulation depth of the chorus effect
Phase 0–180 deg Spatial spread of the sound
Output Mode
SPEAKER,
PHONES
Adjusts the method that will be used to
hear the sound that is output to the
OUTPUT jacks. The optimal 3D effect
will be achieved if you select SPEAKER
when using speakers, or PHONES
when using headphones.
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level
Assignable Parameters
MFX Control
Depth, Rate, Feedback, Balance
Parameter
Value Description
Filter Type
OFF,
LPF,
HPF
Type of filter
OFF : no filter is used
LPF : cuts the frequency range above
the Cutoff Freq
HPF : cuts the frequency range below
the Cutoff Freq
Cutoff Freq 200–8000 Hz Basic frequency of the filter
Pre Delay 0.0–100.0 ms
Adjusts the delay time from when the
direct sound begins until the flanger
sound is heard.
Rate Mode Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00 Hz Frequency of modulation (Hz)
Rate ( ) note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback -98– +98%
Adjusts the proportion of the flanger
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.
Output Mode
SPEAKER,
PHONES
Adjusts the method that will be used to
hear the sound that is output to the
OUTPUT jacks. The optimal 3D effect
will be achieved if you select SPEAKER
when using speakers, or PHONES
when using headphones.
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the flanger sound (W)
Level 0–127 Output Level
Assignable Parameters
MFX Control
StepRate, Depth, Feedback, Balance
Parameter
Value Description
Filter Type
OFF,
LPF,
HPF
Type of filter
OFF : No filter is used
LPF : Cuts the frequency range above
the Cutoff Freq
HPF : Cuts the frequency range below
the Cutoff Freq
Cutoff Freq 200–8000 Hz Basic frequency of the filter
Pre Delay 0.0–100.0 ms
Adjusts the delay time from when the
direct sound begins until the flanger
sound is heard.
Rate Mode Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00 Hz Frequency of modulation (Hz)
Rate ( ) note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback -98– +98%
Adjusts the proportion of the flanger
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.
Step Rate Mode Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
StepRate(Hz) 0.10–20.00 Hz Rate (period) of pitch change (Hz)
Step Rate ( ) note (*1) Rate (period) of pitch change (note)
Output Mode
SPEAKER,
PHONES
Adjusts the method that will be used to
hear the sound that is output to the
OUTPUT jacks. The optimal 3D effect
will be achieved if you select SPEAKER
when using speakers, or PHONES
when using headphones.
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the flanger sound (W)
Level 0–127 Output Level
Assignable Parameters
MFX Control
Low Depth, High Depth, Low Rate, HighRate, Balance
Parameter
Value Description
Split Freq
200–8000 Hz
Frequency at which the low and high
ranges will be divided
Low Pre Delay 0.0–100.0 ms
Delay time from when the original
sound is heard to when the low-range
chorus sound is heard
Low Rate Mode Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
Low Rate(Hz) 0.05–10.00 Hz
Rate at which the low-range chorus
sound is modulated (Hz)
Low Rate ( ) note (*1)
Rate at which the low-range chorus
sound is modulated (note)
Low Depth 0–127
Modulation depth for the low-range
chorus sound
Low Phase 0–180 deg
Spaciousness of the low-range chorus
sound
RD-700GX_e.book 161 ページ ２００８年２月１３日 水曜日 午後５時４９分

Roland RD-700GX Specifications

General

Brand	Roland
Model	RD-700GX
Category	Musical Instrument
Language	English