Roland RS-9 - 27: Overdrive→Flanger; 28: Overdrive→Delay

100
Chapter 6. Effect Settings
27: OVERDRIVE→FLANGER
This effect connects an overdrive and a flanger in series.
fig.MFX-27
OD Drive
Adjust the degree of overdrive distortion. The volume will
change together with the degree of distortion.
Value: 0–127
OD Pan (Overdrive Pan) #1
Adjust the stereo location of the overdrive sound. L64 is far
left, 0 is center, and 63R is far right.
Value: L64–63R
Flg Pre Dly (Flanger Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Value: 0.0–100 [ms]
Flg Rate (Flanger Rate)
Adjust the modulation speed of the flanger effect.
Value: 0.05–10.00 [Hz]
Flg Dpt (Flanger Depth)
Adjust the modulation depth of the flanger effect.
Value: 0–127
Flg Feedback (Flanger Feedback Level)
Adjust the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Flg Balance (Flanger Balance) #2
Adjust the volume balance between the overdrive sound that
is sent through the flanger and the overdrive sound that is
not sent through the flanger. With a setting of “D100:0W,”
only the overdrive sound will be output. With a setting of
“D0:100W,” only the overdrive sound that is sent through
the flanger will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
28: OVERDRIVE→DELAY
This effect connects an overdrive and a delay in series.
fig.MFX-28
OD Drive
Adjust the degree of overdrive distortion. The volume will
change together with the degree of distortion.
Value: 0–127
OD Pan (Overdrive Pan) #1
Adjust the stereo location of the overdrive sound. L64 is far
left, 0 is center, and 63R is far right.
Value: L64–63R
Delay Time
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Value: 0.0–500 [ms]
Delay Feedback (Delay Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Value: -98– +98 [%]
Delay HF Damp
Adjust the frequency above which delayed sound fed back to
the effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Value: 200–8000 [Hz], BYPASS
Delay Bal (Delay Balance) #2
Adjust the volume balance between the overdrive sound that
is sent through the delay and the overdrive sound that is not
sent through the delay. With a setting of “D100:0W,” only the
overdrive sound will be output. With a setting of “D0:100W,”
only the overdrive sound that is sent through the delay will
be output.
Value: D100:0W–D0:100W
L in
R in
Flanger
Overdrive
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
L in
R in
Delay
Overdrive
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback