Roland RS-9 - Changing the Multi-Effect Type

47
Using the Convenient Functions in Performances
Using the Convenient Functions in Performances
Changing the Multi-effect Type
Here’s how to select the desired one of the 42 different Multi-effect settings.
fig.Q-53
1
Set Multi-effects to ON (p. 44).
2
Press [EDIT], getting the indicator to light.
3
Use VALUE [-]/[+] to select “Tone/Drum/PFMCommon.”
4
Press [ENTER].
5
Press [6] a number of times to select “Type.”
fig.Q-54
The figure above shows Source set to UPPER. You can see which multi-
effects settings are being used in the upper left of the display.
6
Press VALUE [-]/[+] to select the type.
7
Press [EDIT].
The [EDIT] indicator goes out, and you are returned to the previous screen.
You can set the Multi-Effects
Type for each Tone or
Performance (p. 56)
individually with the Source
setting.
3,6
42,75
If you hold down [SHIFT]
and press [6], you will
return to the previous item.
When set to
“00:THROUGH,” the
multi-effects are then not
applied.
When you want to know about the Multi-effects in greater detail
• “Chapter 6. Effect Settings” (p. 79)