EasyManua.ls Logo

Roland RS-9 - 18: Modulation Delay

Roland RS-9
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
93
Chapter 6. Effect Settings
Chapter 6
18: MODULATION DELAY
This effect adds modulation to the delayed sound, producing
an effect similar to a flanger.
When Feedback Mode is NORMAL:
fig.MFX-18a
When Feedback Mode is CROSS:
fig.MFX-18b
Delay Left (Delay Time Left)
Adjust the time from the direct sound until when the left
delay sound is heard.
Value: 0.0–500 [ms]
Delay Right (Delay Time Right)
Adjust the time from the direct sound until when the right
delay sound is heard.
Value: 0.0–500 [ms]
Feedback (Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Value: -98– +98 [%]
Feedback Mode
Select the way in which delay sound is fed back into the
effect.
Value
NORMAL: The left delay sound will be fed back into the left
delay, and the right delay sound into the right
delay.
CROSS: The left delay sound will be fed back into the
right delay, and the right delay sound into the
left delay.
Rate #1
Adjust the speed of the modulation.
Value: 0.05–10.00 [Hz]
Depth
Adjust the depth of the modulation.
Value: 0–127
Phase
Adjust the spatial spread of the sound.
Value: 0–180 [deg]
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Value: 200–8000 [Hz], BYPASS
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance) #2
Adjust the volume balance between the direct sound and the
modulation delay sound. With a setting of D100:0W only the
direct sound will be output, and with a setting of D0:100W
only the modulation delay sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
R in R out
L in L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay
Modulation
Modulation
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay
Modulation
Modulation

Table of Contents

Related product manuals