91
Chapter 6. Effect Settings
Chapter 6
16: STEP FLANGER
The Step Flanger effect is a flanger in which the flanger pitch
changes in steps.
fig.MFX-16
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Value: 0.0–100 [ms]
Rate
Adjust the rate of modulation.
Value: 0.05–10.00 [Hz]
Depth
Adjust the depth of modulation.
Value: 0–127
Feedback (Feedback Level) #1
Adjust the amount (%) of the flanger sound that is returned
(fed back) into the input. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Phase
Adjust the spatial spread of the sound.
Value: 0–180 [deg]
Step Rate #2
Adjust the rate (period) of pitch change.
Value: 0.1–20.0 [Hz], note-value symbols
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
flanger sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
chorus sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger
Step Rate parameter can be set as a note-value of a
specified tempo. In this case, specify the value of the
desired note. The Tempo (p. 76) setting changes to the
basic tempo.
To Next Page
Loading...
