Roland RS-9 - Adjusting the Pitch to Other Instruments (Master Tuning)

18
Getting Ready
Adjusting the pitch to other instruments
(Master Tuning)
When playing the RS-5/9 together with other instruments, the pitch of all
instruments must be adjusted to match—otherwise you will be out of tune!
In general, the tuning of an instrument is indicated by the pitch in Hertz
(Hz) of the middle “A” note.
fig.Q-07
1
Press [EDIT], getting the indicator to light.
2
Use VALUE [-]/[+] to select “System Setup.”
3
Press [ENTER].
4
Press [4] a number of times to select “Master Tune.”
fig.Q-08
5
Press VALUE [-]/[+] to set the value (415.3–440.0–466.2).
Match the pitch of the middle “A” note on the RS-5/9 to the other
instruments.
6
Press [EDIT].
The [EDIT] indicator goes out, and you are returned to the previous screen.
The Master Tune setting is
a system setting that is
applied to the entire RS-5/9
(i.e., is a system setting).
This setting remains stored
in memory even while the
power is off.
32,5 1,64
If you hold down [SHIFT]
and press [4], you will
return to the previous item.
The process of putting the
standard pitches in tune is
called “Tuning.”