Roland RS-9 - 23: FBK PITCH SHIFTER (Feedback Pitch Shifter)

97
Chapter 6. Effect Settings
Chapter 6
CoarseB (Coarse Pitch B) #2
Adjust the pitch of Pitch Shift B in semitone steps (-2–+1
octaves).
Value: -24– +12 [semi]
Fine B (Fine Pitch B) #2
Make fine adjustments to the pitch of Pitch Shift B in 2-cent
steps (-100–+100 cents).
One cent is 1/100th of a semitone.
Value: -100– +100 [cent]
Pan B (Output Pan B)
Adjust the stereo location of the Pitch Shift B sound. L64 is
far left, 0 is center, and 63R is far right.
Value: L64–63R
Pre Delay B (Pre Delay Time B)
Adjust the time delay from when the direct sound begins
until the Pitch Shift A sound is heard.
Value: 0.0–500 [ms]
Mode (Pitch Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
Value: 1, 2, 3, 4, 5
Lev Balance (Level Balance)
Adjust the volume balance between the Pitch Shift A and
Pitch Shift B sounds.
Value: A100:0B–A0:100B
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
pitch shift sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
pitch shift sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
23: FBK PITCH SHIFTER
(Feedback Pitch Shifter)
This pitch shifter allows the pitch shifted sound to be fed
back into the effect.
fig.MFX-23
Coarse (Coarse Pitch) #1
Adjust the pitch of the pitch shifted sound in semitone steps
(-2–+1 octaves).
Value: -24– +12 [semi]
Fine (Fine Pitch) #1
Make fine adjustments to the pitch of the pitch shifted sound
in 2-cent steps (-2–+1 octaves).
Value: -100– +100 [cent]
Feedback (Feedback Level) #2
Adjust the proportion (%) of the processed sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the pitch shifted sound is heard.
Value: 0.0–500 [ms]
Mode (Pitch Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
Value: 1, 2, 3, 4, 5
Pan (Output Pan)
Adjust the stereo location of the pitch shifted sound. L64 is
far left, 0 is center, and 63R is far right.
Value: L64–63R
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
L in
R in
L out
R out
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
2-Band
EQ
Feedback
Pitch Shifter