80
Chapter 6. Effect Settings
The Effect Signal Path
The following figure shows the path followed by the effects signals.
fig.R06-01exp
* You can make this setting only when Source is set to PERFORMANCE in the Part’s MULTI-FX Switch setting. When Source is set to
UPPER or LOWER, the Upper or Lower Part’s MULTI-FX SWITCH automatically goes on, and all other Parts are switched off.
Making Multi-Effects Settings
You can use only one type of multi-effect in a Performance.
Be sure to start by setting the Source (Multi-Effects
Source). Here, select the multi-effects settings to be used
based on the particular application or purpose.
Afterwards, select the type, then set each of the parameters
(p. 81).
You can select whether to have the multi-effects used (ON),
or not used (OFF) in each individual Part only when Source
is set to PERFORMANCE (p. 107).
Setting the Multi-Effects Source
Select the multi-effects settings that are to be used based on
the particular application or purpose you have in mind.
You can make different Multi-Effects Source setting for each
individual Performance.
Source (Multi-Effects Source)
Value:
UPPER: The Upper Tone’s multi-effect settings are used.
The multi-effect is applied only to the Upper Part.
LOWER: The Lower Tone’s multi-effect settings are used.
The multi-effect is applied only to the Lower Part.
PERFORMANCE: The Performance’s multi-effect settings
are used. The same multi-effect is
applied to all Parts (1–16).
Make each of the settings according to the desired purpose,
as shown below.
Set to UPPER:
• When Key Mode is set to Single and you want to use the
tone to which multi-effects are applied.
• When Key Mode is set to Split and you want to use the
tone to which multi-effects are applied in the Upper Part.
Set to LOWER:
• When Key Mode is set to Split and you want to use the
tone to which multi-effects are applied in the Lower Part.
Set to PERFORMANCE:
• When Key Mode is set to Split or Dual and you want to
add the same multi-effects to the tones in both Parts.
• If you do not want the multi-effects to change when
switching Tones or Drum Sets.
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select “Tone/Drum/
PFMCommon.”
3. Press [ENTER].
4. Press [6] a number of times to select “Source.”
fig.R06-02
* If you hold down [SHIFT] and press [6], you will return to the
previous item.
5. Use VALUE [-]/[+] to set the value.
Multi-FX
Chorus
Reverb
OUTPUT
(R, L(MONO))
Cho Send
Level to Rev
M-FX Send
Level to Cho
M-FX Send
Level to Rev
Part M-FX
SW
Part Cho
Send Level
Part Rev
Send Level
Tone
Drum Set
*
To Next Page
Loading...
