EasyManua.ls Logo

Roland RS-9 - 06: Enhancer; 07: Auto Wah

Roland RS-9
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
85
Chapter 6. Effect Settings
Chapter 6
Pan (Output Pan) #1
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
Value: L64– 63R
Level (Output Level) #2
Adjust the output level.
Value: 0–127
06: ENHANCER
The Enhancer controls the overtone structure of the high
frequencies, adding sparkle and tightness to the sound.
fig.MFX-06
Sens (Sensitivity) #1
Adjust the sensitivity of the enhancer.
Value: 0–127
Mix (Mix Level) #2
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Value: 0–127
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Level (Output Level)
Adjust the output level.
Value: 0–127
07: AUTO WAH
The Auto Wah cyclically controls a filter to create cyclic
change in timbre.
fig.MFX-07
Filter Type
Select the type of filter.
Value
LPF: The wah effect will be applied over a wide frequency range.
BPF: The wah effect will be applied over a narrow frequency range.
Sens (Sensitivity)
Adjust the sensitivity with which the filter is controlled.
Value: 0–127
Manual #1
Adjust the center frequency from which the effect is applied.
Value: 0–127
Peak
Adjust the amount of the wah effect that will occur in the
area of the center frequency. Lower settings will cause the
effect to be applied in a broad area around the center
frequency. Higher settings will cause the effect to be applied
in a more narrow range.
Value: 0–127
Rate #2
Adjust the frequency of the modulation.
Value: 0.05–10.00 [Hz]
Depth
Adjust the depth of the modulation.
Value: 0–127
Polarity
Sets the direction in which the frequency will change when
the auto-wah filter is modulated. With a setting of Up, the
filter will change toward a higher frequency. With a setting
of Down, it will change toward a lower frequency.
Value: UP, DOWN
Level (Output Level)
Adjust the output level.
Value: 0–127
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
2-Band
EQ
2-Band
EQ
Auto Wah
L out
R out
L in
R in

Table of Contents

Related product manuals