Roland RS-9 - 34: Enhancer→Delay; 35: Chorus→Delay

103
Chapter 6. Effect Settings
Chapter 6
Level (Output Level)
Adjust the output level.
Value: 0–127
34: ENHANCER→DELAY
This effect connects an enhancer and a delay in series.
fig.MFX-34
Enhancer Sens (Enhancer Sensitivity) #1
Adjust the sensitivity of the enhancer.
Value: 0–127
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Value: 0–127
Delay Time
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Value: 0.0–500 [ms]
Delay Feedback (Delay Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the delay input. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Delay HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut. If you do not want to cut the high
frequencies of the delay feedback, set this parameter to
BYPASS.
Value: 200–8000 [Hz], BYPASS
Delay Bal (Delay Balance) #2
Adjust the volume balance between the enhancer sound that
is sent through the delay and the enhancer sound that is not
sent through the delay. With a setting of “D100:0W,” only the
enhancer sound will be output. With a setting of “D0:100W,”
only the enhancer sound that is sent through the delay will
be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
35: CHORUS→DELAY
This effect connects a chorus and a delay unit in series.
fig.MFX-35
Chorus Delay (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Value: 0.0–100 [ms]
Chorus Rate
Adjust the modulation speed of the chorus effect.
Value: 0.05–10.00 [Hz]
Chorus Depth
Adjust the modulation depth of the chorus effect.
Value: 0–127
Chorus Bal (Chorus Balance) #1
Adjust the volume balance between the direct sound and the
chorus sound. With a setting of “D100:0W,” only the direct
sound will be output. With a setting of “D0:100W,” only the
chorus sound will be output.
Value: D100:0W–D0:100W
Delay Time
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Value: 0.0–500 [ms]
Delay Feedback (Delay Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the delay input. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Feedback
Delay
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
Balance W
Balance W
Balance D
Balance D
Feedback
Delay
L in
R in
L out
R out
Balance W
Balance W
Balance D
Balance D
Chorus
Balance W
Balance W
Balance D
Balance D