Roland RS-9 - Playing a Drum Set in a Part Other than Part 10

31
Playing the Sounds
Playing the Sounds
5
Press [ENTER] to finalize the entry.
Playing a Drum Set in a Part Other Than Part 10
You can also Play Drum Sets in Parts other than Part 10.
fig.Q-26
1
Press [EDIT], getting the indicator to light.
2
Use VALUE [-]/[+] to select “Performance Part.”
3
Press [ENTER].
4
Press PART [ ]/[ ] to select the Part to which the Drum
Set is to be assigned.
5
Press [5] a number of times to select “Tone Type.”
fig.Q-27
6
Press VALUE [-]/[+] to select “DRUM1” or “DRUM2.”
7
Press [EDIT].
The [EDIT] indicator goes out, and you are returned to the previous screen.
Instead of using Steps 4
and 5, you can also switch
Drum Sets by pressing
VALUE [-]/[+].
Separate Tone Type
settings can be made for
each individual Part in a
Performance (p. 56).
531,7
2,6
4
When Key Mode (p. 34) is
set to Split or Dual, you can
select only the Upper Part
and the Lower Part.
If you hold down [SHIFT]
and press [5], you will
return to the previous item.
• If you wish to make
settings for other Parts,
repeat steps 4–6.
• If you want to go from
Drum Sets back to
regular Tones, press
“TONE” in Step 6.