98
Chapter 6. Effect Settings
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
pitch shift sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
pitch shift sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
24: REVERB
The Reverb effect adds reverberation to the sound,
simulating an acoustic space.
fig.MFX-24
Type (Reverb Type)
Select the type of Reverb effect.
Value
ROOM1: dense reverb with short decay
ROOM2: sparse reverb with short decay
STAGE1: reverb with greater late reverberation
STAGE2: reverb with strong early reflections
HALL1: reverb with clear reverberance
HALL2: reverb with rich reverberance
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the reverb sound is heard.
Value: 0.0–100 [ms]
Time (Reverb Time) #1
Adjust the time length of reverberation.
Value: 0–127
HF Damp
Adjust the frequency above which the reverberant sound will
be cut. As the frequency is set lower, more of the high
frequencies will be cut, resulting in a softer and more muted
reverberance. If you do not want the high frequencies to be
cut, set this parameter to BYPASS.
Value: 200–8000 [Hz], BYPASS
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance) #2
Adjust the volume balance between the direct sound and the
reverb sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
reverb sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
L in
R in
L out
R out
Reverb
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
2-Band
EQ
To Next Page
Loading...
