Roland TR-8S - Kit: Ctrl; Kit: Color; Kit: Name

28
Editing a Kit’s Settings (KIT Edit)
KIT: CTRL
Parameter Value Explanation
Sel
[CTRL SELECT]
OFF, Pan,
ReverbSend,
DelaySend, LFO
Depth, InstFX,
User
Assigns a parameter to the [CTRL]
knobs of the instrument edit section
so that it can be controlled.
OFF: The [CTRL] knobs do nothing.
Pan: Control the pan of each
instrument.
ReverbSend: Control the reverb send
level of each instrument.
DelaySend: Control the delay send
level of each instrument.
LFO Depth: Control the LFO effect
depth of each instrument.
InstFX: Control the INST FX effect
that’s selected for each instrument.
User: Control the parameter that’s
assigned for each instrument.
BD
SD
LT
MT
HT
RS
HC
CH
OH
CC
RC
*2
OFF, Pan,
ReverbSend,
DelaySend, LFO
Depth, InstFX,
(BD) Attack
(SD) Snappy
(TOM) Color
(SAMPLE)
Coarse, Rate,
Spread,
BitReduce,
Attack,
HoldMode,
HoldTime,
HoldStep,
FltType,
FltCutoff,
FltReso,
FltEnvAtk,
FltEnvDecay,
FltEnvDepth,
FltVelo
This is shown only if you’ve set
CTRL Sel = User. It lets you assign a
parameter for each instrument to the
[CTRL] knobs of the instrument edit
section.
KIT: COLOR
Parameter Value Explanation
BD
SD
LT
MT
HT
RS
HC
CH
OH
CC
RC
*2
RED, ORANGE,
YELLOW,
LIME, GREEN,
SKYBLUE,
LIGHTBLUE,
BLUE, PURPLE,
MAGENTA,
PINK, WHITE
Specifies the color that each level
fader BD–RC will be when SLIDER LED
Src is set to kit.
When the cursor is located at color
(value), you can also specify the color
by moving the slider.
KIT: NAME
Parameter Explanation
NAME Specifies the name of the kit (maximum 16 characters).
How to enter characters
1. Use the [VALUE] knob to select “NAME.”
2. Press the [ENTER] button to access the character
input screen.
Controller Explanation
[VALUE] knob Change the character.
[UTILITY] button Moves to the right.
[COPY] button Moves to the left.
[SHIFT] button
+[COPY] button
Deletes one character (Erase).
[SHIFT] button
+[UTILITY] button
Inserts one character (Insert).
[SHIFT] button
+[VALUE] knob
Switches between uppercase/lowercase/
numerals.
3. When you’ve finished inputting characters, press
the [ENTER] button.