Roland V-8HD - Page 50

50
Other Features
Initializing a Macro
You can initialize a macro and completely erase its settings.
1. Press the [MENU] button0“MACRO”0select
“INITIALIZE,” and press the [VALUE] knob.
2. Use the [VALUE] knob to the macro you wish to
select (ALL, 1–100), and press the [VALUE] knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
3. Use the [VALUE] knob to select “YES,” and press the
[VALUE] knob.
The macro is initialized. When the operation is nished, the
message “COMPLETE” appears.
4. Press the [MENU] button to close the menu.
MEMO
About the macro demo data
Once you perform a factory reset (p. 64), any demo data you
have edited or deleted is restored to its factory default settings.
Renaming a Macro
Here’s how to rename a macro.
1. Press the [MENU] button0“MACRO”0select “NAME
EDIT,” and press the [VALUE] knob.
2. Use the [VALUE] knob to select the macro (1–100)
that you want to rename, and then press the
[VALUE] knob.
The MACRO NAME EDIT screen appears.
3. Input the macro name.
* You can input up to 8 characters.
INIT: Initializes the name.
1
Use the [VALUE] knob to move the cursor.
Pressing the [EXIT] button deletes the character at the cursor
location.
2
Press the [VALUE] knob to highlight the character at the cursor
location.
3
Use the [VALUE] knob to change the character, and then press
the [VALUE] knob.
4. When you have nished inputting the name, use
the [VALUE] knob to select “CLOSE,” and then press
the [VALUE] knob.
* If you decide to cancel, press the [EXIT] button.
5. Press the [MENU] button to close the menu.