Roland V-Drums TD-30 - Erasing Patterns and Measures

Pattern Sequencer
103
Connecting Two Patterns
(APPEND)
This connects two patterns to create one pattern. The
pattern specied as “Dst” will be rst, and the pattern
specied as “Src” will be connected to it. The new pattern
will be created in “Dst.”
Src Dst
1
1
2
2
3
3
4
4 5
1
6
3 4
8
2
7
1. In the PATTERN EDIT screen (p. 101), press the [F2]
(APPEND) button.
The PATTERN APPEND screen will appear.
2. Use the cursor [ ] [ ] buttons, the [–] [+]
buttons, or the dial to select the pattern that you
want to append.
Pattern that will come later
Pattern that will come earlier
3. Press the [F5] (APPEND) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
4. Press the [F5] (EXECUTE) button.
The patterns will be appended.
Erasing a Pattern (ERASE)
This erases the pattern. Performance data is erased, while
beat, measure length, and other settings are left intact.
1
1
2
2
3
3
4
4
5
5
6
6
8
8
7
7
You can erase portions of the pattern, in measure units.
The erased portions become blank measures.
1
1
2
2
3
3
4
4
5
5
6
6
8
8
7
7
MEMO
Although the data is erased, the pattern length is
unchanged.
1. In the PATTERN EDIT screen (p. 101), press the [F3]
(ERASE) button.
The PATTERN ERASE screen will appear.
2. When you want to erase selected measures or
part, press the [F4] (MEASURE) button.
The PATTERN ERASE MEASURE screen will appear.
3. Use the cursor [ ] [ ] buttons, the [–] [+]
buttons, or the dial to select the pattern, part, or
measures that you want to erase.
Pattern to erase
Part to erase
Range of measures to
erase (rst measure -
last measure)
AppendicesExpansionSettingsPerformanceSetupOverview