Roland V-Drums TD-30 - Loading Patterns from USB and Deleting USB Patterns

Pattern Sequencer
106
Loading a Pattern from a USB
Flash Drive (LOAD)
Patterns saved on a USB ash drive can be loaded into
the TD-30.
1. Connect your USB ash drive to the TD-30’s USB
MEMORY port (p. 85).
2. In the PATTERN EDIT screen (p. 101), press the [F5]
(USB MEM) button.
The PATTERN USB screen will appear.
3. Press the [F2] (LOAD) button.
The PATTERN LOAD screen will appear.
4. Press the cursor [ ] button, and then use the [–]
[+] buttons or the dial to select the number of
the pattern that you want to load.
5. Press the [ ] button, and then use the [–]
[+] buttons or the dial to select the loading-
destination for the pattern.
6. Press the [F5] (LOAD) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
7. Press the [F5] (EXECUTE) button.
The pattern will be loaded.
Deleting a Pattern from a USB
Flash Drive (DELETE)
You can delete the unneeded pattern from a USB ash
drive.
1. Connect your USB ash drive to the TD-30’s USB
MEMORY port (p. 85).
2. In the PATTERN EDIT screen (p. 101), press the [F5]
(USB MEM) button.
The PATTERN USB screen will appear.
3. Press the [F3] (DELETE) button.
The PATTERN DELETE screen will appear.
4. Use the [–] [+] buttons or the dial to select the
number of the pattern that you want to delete.
5. Press the [F5] (DELETE) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
6. Press the [F5] (EXECUTE) button.
The pattern will be deleted.