Roland V-Drums TD-30 - Adjusting the Hi-Hat and Mesh Pads; Hi-Hat Offset Adjustment

40
Adjusting the Hi-Hat and Mesh Pads
Making Hi-hat Settings
If you’re using the VH-13, VH-12, or VH-11 V-hi-hat, adjust the oset on the TD-30.
This adjustment is required for pedal movements such as open or close to be detected correctly.
* If you do not make hi-hat’s setting correctly, it may cause malfunction. For details on attaching the hi-hat to the stand, refer
to the owner’s manual of each device.
Settings for the VH-13/VH-12
1. Set the Trigger Type for hi-hat to “VH13” (or “VH12”) (p. 126).
2. In the TRIGGER HI-HAT screen (p. 128), press the [F4] (OFFSET) button.
The VH OFFSET ADJUSTMENT screen will appear.
MEMO
You can also adjust the oset by holding down the TD-30’s [KIT] button and pressing the [TRIGGER] button.
3. Loosen the clutch screw of the top hi-hat and let it sit on the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
4. Press the [F5] (EXECUTE) button.
The “VH Oset” parameter is set automatically (approx. 3 seconds).
The [TRIGGER] button stops ashing and remains lit.
MEMO
If you need, make further adjustments to the parameters, refer to “Hi-Hat Settings (HI-HAT)” (p. 128).
Settings for the VH-11
1. After making the hi-hat settings, release your foot from the pedal, and while keeping your foot o the pedal,
turn on the unit to the TD-30.
2. Loosen the clutch screw and let the hi-hat rest naturally on the motion sensor unit.
3. Press the [TRIGGER] button.
4. Press the [F3] (HI-HAT) button.
The TRIGGER HI-HAT screen will appear.
5. Set the Trigger Type for hi-hat to “VH11” (p. 126).