Roland V-Drums TD-30 - Restoring Factory Settings (F RESET)

Overall Settings for the TD-30 (SETUP)
122
Restoring the Factory Settings
(F RESET)
This restores the TD-30 to the original factory settings
(Factory reset).
NOTE
When you execute this operation, all data and
settings in the TD-30 will be lost. Before you proceed,
you should save any important data and settings to
your USB ash drive (p. 108).
1. In the SETUP A screen (p. 114), press the
[F4] (F RESET) button.
The FACTORY RESET screen will appear.
2. Press the [F5] (F RESET) button.
A conrmation message will appear.
If you decide to cancel the factory reset, press the [F1]
(CANCEL) button.
3. Press the [F5] (EXECUTE) button.
The factory reset will be executed.
When the factory reset has been completed, a screen like
the following will appear.
4. Specify whether you want to enable or disable
the auto o function (p. 124).
When you make settings for the auto o function, a
screen like the following will appear.
5. Use the [–] [+] buttons or dial to select the
Trigger Type (p. 126).
6. As described in screen, adjust the oset.
MEMO
The oset adjustment is necessary in order to
correctly detect open/close and pedal movements.