Ross Carbonite Series - Patterns, Washes, and Mattes; Patterns; To Set Up a Pattern; Washes

6.
Double-press the Clip knob to select the default
6.3%.
7.
Press NEXT > NEXT > NEXT.
8.
Use the Box knob to select box one for the
MultiViewer you are using for ViewControl.
For example, if you are assigning MultiViewer
one (1) to ViewControl, select MV1:1.
9.
Use the In/Out knob to select PV.
10.
Use the Box knob to select box two.
11.
Use the In/Out knob to select PGM.
12.
Assign additional sources to the remaining
MultiViewer boxes. These are the sources that
will be available in ViewControl.
Carbonite Setup Manual (v10.0) — ViewControl • 33
USO RESTRITO