Ross NK-16 - Page 64

4–18 • Configuration NK Series User Guide (1.0)
Cutbus Destination 2
Configures the Cutbus destination of the bottom row of keys when no DESTINATION or CROSSPOINT keys have
been assigned. The valid range for the Cutbus Destination 2 is 1-255.
Breakaway Reset
When enabled the Breakaway Reset option resets to the first breakaway (Default Breakaway) after a crosspoint
switch. By default, the Breakaway Reset is off (check box is cleared).
Breakaway Warning Mode
The Breakaway Warning Mode determines which breakaway the current switch status is compared with to check if
a Breakaway Warning condition has occurred. Two modes are available, Current (Current Breakaway) and Default
(First Breakaway).
On Brightness
The On Brightness sets the LED brightness for the RCP-NK1 control panel buttons when the button is ‘on’; that is
when it has been pressed, is already active, or when indicating an error by several quick flashes. The default value
is 200. The valid input value range is 1-250.
The On Brightness does not necessarily have to be a higher value than that of the Off Brightness, although it is
generally advised to avoid confusion.
Table 4.6 Configuration Values
Key Default Value Shift Value Shift2 Value Value Range
Dest (Output) # (DESTINATION SHIFT 1)
Output #
(DESTINATION SHIFT 2)
Output #
Output = 1-65535
The value range for DESTINATION keys is 1-255, representing any valid output value. There may be three pages/sets of
DESTINATION keys on any one panel (the default page, first DESTINATION SHIFT page and one second
DESTINATION SHIFT page).
Source (Input) # (SOURCE SHIFT 1)
Input #
(SOURCE SHIFT 2)
Input #
Input = 1-65535
The value range for SOURCE keys is 1-255, representing any valid input value. There may be three pages/sets of SOURCE
keys on any one panel (the default page, first SOURCE SHIFT page and one second SOURCE SHIFT page).
Xpoint (Destination) # (Source) # (Breakaway/Level) # Source/Destination = 1-255
Breakaway = 1-16
Level = 17-24 (Level # +16)
The CROSSPOINT key requires a destination value, a source value, and a breakaway or level value to be correctly defined.
Level (Level) # — — Level = 1-32
For details on levels and formats, please refer to “Default Configuration” on page 4–1.
Breakaway (Breakaway) # — — Breakaway = 1-16
For details on assigning breakaways, please refer to “Breakaways” on page 4–17.
Brk Step————
USO RESTRITO