Introduction
AC-115 Software Installation and User’s Guide Page 4
1. Introduction
Thank you for purchasing the AC-115 single door, self-
contained access controller and AC-115 PC software.
The AC-115 is an advanced single door controller capable of
being networked with up to seven more AC-115s.
A single AC-115 can be used without PC Software.
Programming the AC-115 without the PC software (local
programming) is accomplished via the AC-115’s membrane
keypad. However, there are many features that can only be
set by the AC-115 PC software.
The PC software must be used when more than one AC-115 is
joined in a network of doors.
This manual explains how to install and use the AC-115 PC
software with one or more doors.
This section describes this manual, and how to choose the right
operating system and the necessary hardware required to use
your AC-115 system.
The topics in this chapter are:
• How to Use this Manual
• Select the Right Operating System
• Select the Right PC Hardware
• Install the AC-115 PC Software
Note:
This manual refers to the AC-115 software version 33.9.08
and above.
To Next Page
Loading...
Need help?
General
