EasyManua.ls Logo

Rotax MML-912 - Checking the Air Filter; Cleaning the Dry Air Filter

Rotax MML-912
170 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
d02880.fm
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2 / Rev. 0
12-20-00
page 5
October 01/2009
2) Checking air filter
General note
Carry out visual inspection of dry air filter after prescribed maintenance
interval. Clean dirty air filter as described in aircraft manufacturers Main-
tenance Manual.
2.1) Cleaning the dry air filter
General note
Cleaning To clean the dry filter the following steps are necessary:
See Fig. 1 and Fig. 2.
WARNUNG
NOTICE
In the event of dust formation, clean air filter at corre-
spondingly shorter intervals. If filter mat is damaged,
replace air filter.
WARNUNG
NOTICE
A dirty filter insert will not only reduce the engine per-
formance but might also promote premature wear of
the engine.
WARNUNG
NOTICE
Never use gasoline, steam, caustic liquids, strong de-
tergents, particle cleaning agents or high pressure
cleaners during this step.
WARNUNG
NOTICE
Do not dry over naked flame, with compressed air or
with hot air gun.
Step Procedure
1 Lightly tap and brush off surface dirt (A).
2 Spray K&N filter cleaner onto filter surface and leave to soak for approx. 10
min. (B).
3 Rinse air filter with low pressure water from inside to outside and let element
dry naturally (C).

Table of Contents

Related product manuals