d02880.fm
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2 / Rev. 0
12-20-00
page 54
October 01/2009
11.6) Cleaning the oil tank
See Fig. 27.
General note NOTES: This procedure is optional and requires venting of the oil
system. See chap. 12-20-00 section: 11.7).
It is only necessary to clean the oil tank and the inner parts
if there is heavy oil contamination.
Procedure Procedure to clean the oil tank:
Step Procedure
1 Detach the profile clamp (2) and remove the oil tank cover (3) together with
the O-ring (4) and the oil lines.
2 Remove the inner parts of the oil tank such as the baffle insert (5) and the par-
tition (6).
3 Clean oil tank (8) and inner parts (5, 6) and check for damage.
WARNUNG
NOTICE
Incorrect assembly of the oil tank components can en-
gine faults or engine damage.
Step Procedure
4 Fit drain screw (1) M12x12 with a new gasket ring.Tighten to 25 Nm
(18.5 ft.lb).
5 Safety wire.
6 Reassemble the oil tank by following the same steps in reverse order.
To Next Page
Loading...
