d02874.fm
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2 / Rev. 0
05-00-00
page 9
October 01/2009
21 n.a. Cleaning agents
Use only approved cleaning
agents (e.g. kerosine, varsol,
etc.) for cleaning all metal
parts.
Do not use lye-based cold cleaner or degreasing
agents. Do not clean coolant or oil hoses with
aggressive solutions. Clean off sealing com-
pound residue with sealant remover.
Soak combustion chamber, piston and cylinder
head with cleaning agent and remove combus-
tion residues with a bronze brush. Very good re-
sults have been achieved with “Clenvex 2000“.
It is a solvent-cold cleaner, free of halogen, on
the basis of selected fuel fractions with tensides
and is biologically disposable.
Never use caustic or corrosive cleaning agents.
22 n.a. MICRONORM abrasive
This abrasive is suitable for local and gradual
very fine treatment of steel parts with rust film
(propeller shaft). The MICRONORM abrasive
contains no noxious matter, is approved by the
relevant authorities and guarantees optimum
cleaning. The granulates used are of sizes 40 to
60 µ. It is possible to achieve a surface rough-
ness of 0,5 to 1µ, which represents fine process-
ing of surfaces.
23 n.e. LOCTITE 7063
Degreasing fluid. For parts cleaning before appl-
cation of adhesives and sealants.
No. part no. Description, Application Qty.
NOTICE
To Next Page
Loading...
