Rover ST2 - DATA LOGGER

Brief description
Measurement start up
Push buttons and displays
pag. 32
ST2 User’s Manual
TV Mode
10.0 DATA LOGGER
The Data Logger function allows automatic measurements on all channels in
a given Memory Plan. These measurements can be made at the antenna or at
any installation outlet.
• Press the DATA LOGGER [13] key,
• Use the SELECT [10] , UP [7] and DOWN [9] keys to choose:
a) the Memory Plan to be used for the automatic measurements,
b) the LOGGER fi le, where the measurements will be memorised (from 1 to 99),
• Start the Logger function, highlighting with the SELECT [10] key the command
SAVE? and pressing the UP [7] or DOWN [9] keys to confi rm,
• A status bar indicates that the task is in progress. When the measurements
are completed the display shows the message “DONE!”.
Fig. 10.1 Data Logger display
NOTES:
• All the automatic measurements are carried out on the selected Memory Plan,
• The maximum number of logger fi les is 99,
• The logger fi les can be exported to EXCEL® spread sheets using the SMART program,
• The meter shows the OVERWRITE command if the chosen logger fi le already exists.
Press the
key to start the automatic measurements.
Use the key to highlight the fi elds to be changed and set the required
and
values using the
Memory plan where are carried out the measurements
Logger fi le where the measurements will
be stored: from LOG 01 to max. LOG 99
Memorisation: SAVE? or OVERWRITE?
keys