Brief description
Measurement start up
Push buttons and displays
pag. 10
ST2 User’s Manual
Introduction
CONFIGURATION MENU
The confi guration menu will allow you to set the main working parameters that
will be applied during the meter operation. This menu will also enable some
special functions like “FILE
MANAGER” (to cancel memory plans),
• Press the “MPEG PROG SERVICE” [1] key for 2 seconds
• On display [2] the Confi guration Menu will be shown
• Select “VOLUME” to change the meter volume setting,
• Select
“METER SET UP” to access the typical meter settings,
• Select “TV CONFIG & COUNTRY” to set the canalisation and TV standard to be
used during all measurements,
• Select “SAT CONFIG.” to chose a SAT standard,
• Select “FILE MANAGER” to delete memory plans,
• Select “DiSEqC MOTOR” to drive a motorized antenna.
fi g. 1.0
Press key
for 2” to display the confi guration menu
To Next Page
Loading...
