Roxell CoMeo - Page 17

ROXELL - 001 - 2415
COMEO - INSTRUCTIONS FOR THE USER
I-9
PROBLEM CAUSE CORRECTIVE ACTION
8.Windows are open
and feed level is
too low.
Some windows are actually closed. Adjust height of feeder line until all windows
completely open and close simultaneously.
9.Windows are
closed and feed
level is too high.
Adjuster ring set too high. Adjust height. See OPERATOR'S GUIDE.
Not all windows are closed or
completely closed.
Adjust height of feeder line until all windows
completely open and close simultaneously.
10.Windows are
closed and feed
level is too low.
Adjuster ring set too low. Adjust height. See OPERATOR'S GUIDE.
Feeder line not winched up high
enough.
Winch up feeder line higher until all pans
simultaneously are clear of the litter.
11.Hopper 1 is
empty while the
feed
level in the
second hopper
corresponds with
the position of
the level switch
Birds massively move to one side of
the house, i.e. depending upon the
position of the sun.
A. The problem occurs sporadically :
You can solve the problem by changing the
round hole in the Flex-Auger tube above
hopper 1 into a rectangular one. Install two
outlet drops above hopper 1 (see fig. 3.) if
necessary, so that more feed drops into
hopper 1. Install the level switch low in hopper
2 (see fig. 2 .). Install and adjust drop tubes to
all hoppers high enough.
B. The problem occurs regularly
:
Installalevelswitchhighineachhopper.
Install the level switch low in the last hopper.
Install and adjust the drop tube high, so that
the feed in tube A (over switch level) is carried
to hopper 2.
Drop tube installed and
adjusted high.
Level switch installed
low.
Hopper 1
Hopper 2
FIGURE 1.
FIGURE 2.
A
Hopper 2
Case a.
Large feed reserve (A) in
case b.
Hopper 1
FIGURE 3.