ROXELL - 001 - 1020
COMEO - INSTALLATION INSTRUCTIONS
LED LIGHT KIT F/ INTERM. CONTROL UNIT II-33.......................................
SPARES SET BEAR.CAP HOLD - Ø44.5 II-34...........................................
PART III : INSTALLATION INSTRUCTIONS
GENERAL SAFETY RULES III-3.......................................................
GENERAL LAY-OUT III-4.............................................................
COMPONENT NUMBERS III-5........................................................
TOOLS III-6.........................................................................
ELECTRICITY .... WATCH OUT ! III-7..................................................
ELECTRICAL WIRING DIAGRAM III-7..................................................
THE SUSPENSION III-8..............................................................
SUSPENSION COMPONENTS III-8....................................................
DRAWINGS OF SUSPENSION SYSTEM WITH CENTRAL WINCH III-9....................
CENTRAL WINCH III-11...............................................................
SUSPENSION FOR FEEDER LINE III-12................................................
TO INSTALL THE MAIN CABLE III-14...................................................
TIGHTEN MAIN CABLE III-19..........................................................
TO INSTALL THE LINE III-20...........................................................
POSSIBLE FEEDER PAN COMBINATIONS III-20.........................................
POSSIBLE FEEDER PAN COMBINATIONS III-21.........................................
TO INSTALL THE FEEDER PANS III-22.................................................
CHICK STARTER OUTLET ASS'Y KIT (OPTION) III-31....................................
TO INSTALL THE SHUT OFF SLIDE III-32...............................................
TO INSTALL THE FEEDER LINE III-33..................................................
TO INSTALL THE INTERMEDIATE CONTROL III-35......................................
TO INSTALL THE TUBE WITH HOLE III-35..............................................
CONTROL PANEL INTERMEDIATE CONTROL UNIT (WITH SENSOR) III-36................
FEED INTAKE BOOT III-37............................................................
OPTION: SUPPORT FOR HOPPER IN LINE III-37........................................
TO INSTALL AND SUSPEND THE 100KG HOPPER III-38.................................
TO INSTALL THE CONTROL UNIT III-39................................................
POWER UNIT SUSPENSION III-39.....................................................
CONNECTION BOX KIT FOR CONTROL PAN (FOR US ONLY) III-40.......................
TO INSTALL THE AUGER III-42........................................................
TO INSTALL THE THUMPER (OPTION) III-48............................................
ADJUSTMENT III-49..................................................................
ADJUSTMENT LIMIT SWITCH III-50....................................................
CONNECTION DIAGRAM : SEE CP CENTRAL WINCH III-50..............................
TO INSTALL THE POULTRY PERCH GUARD III-51.......................................
TO INSTALL THE FLEX AUGER FEED SUPPLY SYSTEM III-54............................
TO INSTALL THE TELESCOPICAL TUBE III-55..........................................
ELECTRICAL SYMBOLS III-56.........................................................
WIRING DIAGRAM FOR 1X230V III-57..................................................
WIRING DIAGRAM FOR 3X230V III-58..................................................
WIRING DIAGRAM FOR 3X400V III-59..................................................
LED LIGHT KIT FOR CONTROL UNIT III-60..............................................
LED LIGHT KIT FOR INTERMEDIATE CONTROL UNIT III-61..............................
MOTOR PROTECTION III-62...........................................................
MAXIMUM CABLE LENGTHS TO THE MOTORS III-63....................................
To Next Page
Loading...
