Chapter 6 • IR Library Manager
71
HOW TO ADD A NEW REMOTE TO AN IR LIBRARY
1. Click on the
New
button on the upper right hand side of the
Edit View
dialog box.
2. This will open the
Create New Remote
dialog box.
3. Enter the manufacturer’s name, type of equipment, (such as TV, VCR,
Drapes, Lights and so on) and model number of the component or remote
in the appropriate fields.
4. In the function field, enter the name of the actual commands you are
going to learn (such as Channel+, Channel-, Volume+, Volume-, Power, 1,
2, 3 and so on).
5. After you enter each function name click on the
Add
command button to
save, you can always edit the name of a function later if you make a
mistake or add a function.
6. Repeat steps 4 and 5 for each button on the remote.
7. When done entering information about new remote, click on the
OK
command button to save and close.
To Next Page
Loading...
Need help?
General
