Chapter 3 • TheaterTouch Designer Software
15
Chapter 3. TheaterTouch Designer
Software
TheaterTouch Designer allows you to create the entire graphical interface for an RTI
TheaterTouch System Controller on your computer. Once the interface has been
created, it is downloaded to the TheaterTouch using the included programming cable.
Existing programming can also be extracted, modified, and re-sent to any
TheaterTouch system controller.
Software updates will be available for download at www.rticorp.com
INSTALLING THEATERTOUCH DESIGNER
1. Close any open programs.
2. Place the TheaterTouch Designer compact disc into the CD- ROM drive.
3. If the installation doesn’t appear automatically, click
Start
and choose
Run,
type
d:\setup\setup.exe
(For d, type the letter for your CD-ROM
drive). Click
OK
.
4. Follow the on-screen instructions.
PROGRAMMING OVERVIEW
Here is an overview of the process of programming a TheaterTouch from scratch.
Instructions on carrying out these tasks can be found in chapters 4 and 5.
1. Create a new page and add buttons for each source component in a
system.
2. Place a button on the main menu to access each one of the source
components.
3. Use the Assign Page tool to link the buttons on the main menu to their
respective source component pages.
4. Assign infrared codes and other commands to buttons using the
Command Library.
5. Create macros using the macro editor (if needed).
6. Check the Remote Properties.
7. Save the file.
8. Send the file to the TheaterTouch using the communications commands.
To Next Page
Loading...
Need help?
General
